Product Introduction

This product is an inorganic coolant compound, does not contain phosphate, amine and nitrite, can provide excellent protection for the copper, the brass, the steel, the cast iron, the solder, the cast aluminum and other metal materials in the engine cooling system, especially the aluminum alloy materials protection, so it can be applied for the production of high quality environmental protection engine coolants. Product standard: The engine coolants produced with KHC1022 meet the international and the domestic standards including GB 29743-2013, NB/SH/T 0521-2010, ASTM D3306, SAE J1034, JISK2234, and BS6580, etc.

Physicochemical Property

Production and Use Guide

1.     Suggestions for the Use of Compound

The dosage of this compound is 4-5%. The glycol coolant concentrate prepared with 4% (additional method) can fully meet the requirements of GB29743-2013, NB/SH/T 0521-2010, ASTM D3306 and other standards. If there are higher requirements for coolant reserve alkalinity, the dosage can be increased to 5%.

Concentrate Formulation

Coolant Formulation

2.     Production Blending Technics

 Coolant Production

Ethylene glycol is first added to the mixing tank, and then the compound is added under agitation according to the composition of the coolant formula. Control the adding speed of the compound, so that the compound can be immediately dispersed into ethylene glycol in the mixing tank, and stir for 20-30 minutes after the compound is added. Add deionized water and stir for 30 minutes to check freezing point and pH. After passing the inspection, add the defoamer and pigment, stir to dissolve and disperse evenly to obtain the finished product.

Concentrate Production

The glycol is added to the stirring kettle, and then the compound is added under agitation according to the composition of the concentrate formula. Control the adding speed of the compound so that it can be immediately dispersed into the glycol solution in the mixing tank. After the compound is added, stir for 20 - 30 minutes to detect pH value and freezing point. After passing the inspection, add the defoamer and the pigment according to the demand, stir and dissolve to disperse evenly and get the finished product.

3.     Physicochemical Properties and Product Features of the Concentrate Produced with the Compound

3.1 Physical and Chemical Properties of Concentrate

3.2 Corrosion Resistance of Concentrate (Compound Dosage of 4%)

Corrosion of Glassware

SH/T 0085 (ASTM D 1384)

Heat Transfer Corrosion of Cast Aluminum Alloy

SH/T 0620 (ASTM D 4340)

Aluminum Pump Cavitation Corrosion

SH/T 0087 (ASTM D 2809)

Simulation Corrosion

SH/T 0088 (ASTM D 2570)

Packing and storage

◇Plastic barrel, 220 kg/barrel.

◇Safety protection: It is strictly prohibited to stray into the mouth and eyes, and has an irritating effect on the skin. Production personnel should wear protective equipment when working, such as overalls, rubber gloves, rubber or plastic aprons, rubber boots, protective glasses, etc. Pay attention to the protection of respiratory organs and skin, if accidentally splashed on the skin, should immediately rinse with plenty of water, serious cases should be immediately sent to the hospital for diagnosis and treatment.

◇Store and transport as non-dangerous goods. Store in a cool, dry and ventilated place above 0℃.